[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: make distcheck and the /etc dir
From: |
Daniel Leidert |
Subject: |
Re: make distcheck and the /etc dir |
Date: |
Sun, 10 Jun 2007 22:24:05 +0200 |
Am Sonntag, den 10.06.2007, 09:01 +0200 schrieb Ralf Wildenhues:
> * Daniel Leidert wrote on Mon, Jun 04, 2007 at 07:38:18PM CEST:
> > Am Montag, den 04.06.2007, 15:56 +0200 schrieb Jason Curl:
> > >
> > > # Makefile.am for installing configuration data
> > > etcdir=/etc/lx2005
> >
> > This line misses a $(DESTDIR) to not break package builds and distcheck.
>
> No, it doesn't.
>
> > > etc_DATA = serlog.conf
> > [snip]
> > > The configuration that gets copied depends on the 'configure' script
> > > setting the variable $(MACHINE).
> > >
> > > When I run 'make distcheck' it fails as it cannot install the files to
> > > '/etc/lx2005'. I would very much like the location of the configuration
> > > files to be independent of $(prefix) as the locations my project
> > > searches are independent of where it was installed.
> >
> > No problem: But you should add the DESTDIR variable to hardcoded paths.
>
> Only in rules.
You are right. I already found my mistake.
Regards, Daniel
- Re: make distcheck and the /etc dir, (continued)
Re: make distcheck and the /etc dir, Daniel Leidert, 2007/06/04
Re: make distcheck and the /etc dir, Ralf Wildenhues, 2007/06/10
- Re: make distcheck and the /etc dir,
Daniel Leidert <=