On Tuesday 03 February 2009, Royce Pereira wrote:
Hi,
I am trying to program an AT-tiny26 using AVRdude under Windows.
I always get a 'failed' message while programming hfuse & lock bits.
The flash gets programmede properly though & the chips functions OK.
My programmer is USBASP.
I am pasting below the output of avrdude.
Can anyone explain the error messages? Thanks.
<snip>
avrdude: reading input file "0xFC"
avrdude: writing lock (1 bytes):
Writing | ***failed;
################################################## | 100% 0.11s
avrdude: 1 bytes of lock written
avrdude done. Thank you.
0xFC is setting your lock bits. Refer to pages 109-110 of the datasheet.