Re: [avr-chat] timeout error on STK500

[Irving Ruan]

On Thu, Aug 20, 2009 at 7:58 PM, Weddington, Eric <address@hidden> wrote:

> -----Original Message-----
> From: avr-chat-bounces+eric.weddington=atmel.com@nongnu.org
> [mailto:avr-chat-bounces+eric.weddington=atmel.com@nongnu.org]
>  On Behalf Of Irving Ruan
> Sent: Thursday, August 20, 2009 8:51 PM
> To: address@hidden
> Subject: [avr-chat] timeout error on STK500
>
> After getting some things set up, I wrote some test code and
> assembled it to Intel Hex so I could write it to flash on my
> STK500. Unfortunately, I've been receiving these
> ReceiveMessage() timeout errors and did some research online
> but I honestly think the USB/RS-232 adapter is the culprit
> (from what I've heard, it doesn't work too well with AVRDUDE).
>
> This is what I'm typing to verify that my STK500 is
> interfaced correctly: avrdude \-c stk500v2 \-p m324p \-P
> /dev/ttyUSB1 and this is what I receive:

Are you actually typing the backslashes (above) on the command line?

No. I was also thinking if I should specify the baudrate in the verification, such as 115200..
-- 
Irving Y. Ruan
address@hidden