[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [avr-chat] Programming the efuse on ATmega1280

From: Ormund Williams
Subject: Re: [avr-chat] Programming the efuse on ATmega1280
Date: Sun, 03 Feb 2013 17:37:44 -0500

On Sun, 2013-02-03 at 22:04 +0100, Joerg Wunsch wrote:
> It's not "flipping", it (apparently) *is* set to 0, for whatever
> reason.
Then the error is really in the Atmel documentation, it says the default
value is 1.  When I assemble the next board I'll check to see if the
blank chip efuse reads as 0xFF or 0xF7.


> Alternatively, you could specify it as 0xf4 in the first place.
That's what I'm doing and as long as Atmel dose not change the meaning
of bit3 everything will be fine. 


reply via email to

[Prev in Thread] Current Thread [Next in Thread]