|
From: | Kyle Roberts |
Subject: | [avr-chat] Help with ftdi_syncbb |
Date: | Thu, 17 Sep 2015 15:06:30 +0000 |
Having issues with an ftdi_syncbb based programmer. I was able to find binaries for AVRDUDE 5.11 which were built with libftdi1 support. However this version of AVRDUDE has a bug where the read thread would not close. See http://savannah.nongnu.org/patch/?8419
I am trying to build AVRDUDE from SVN in MinGW. I have successfully built it with the following config:
Configuration summary: ---------------------- DON'T HAVE libelf DO HAVE libusb DO HAVE libusb_1_0 DO HAVE libftdi1 DON'T HAVE libftdi DO HAVE libhid DO HAVE pthread DISABLED doc ENABLED parport DISABLED linuxgpio
However when I run avrdude, I get the error reporting that the device has not responded to Program Enable. I know that the programmer and device are connected correctly since everything runs fine in 5.11
Could it be that my build is pulling bad dependencies or possibly the programmer pin scheme has changed in the avrdude.conf? Any ideas? Thanks. Kyle Roberts QRC Technologies 540-300-8736 . Direct Dial This email is intended solely for the person or entity to which it is addressed and may contain confidential and/or privileged information. Any review, dissemination, copying, printing, or other use of this email by persons or entities other than the addressee is strictly prohibited. If you have received this email in error, please contact the sender immediately and delete the material from any computer. |
[Prev in Thread] | Current Thread | [Next in Thread] |