[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[avr-gcc-list] After ATMega
From: |
Eric Pasquier |
Subject: |
[avr-gcc-list] After ATMega |
Date: |
Thu, 13 Oct 2005 10:05:37 +0200 |
Dear All,
I am using an ATMega32, 16MHz to implement a Kalman filter (7 input states).
I suceed to run it at 60Hz, but with lots of optimization and compromises,
like using fix floating point math for example.
ADC, timers, serial, I/O are used.
I would like to have more capacity for calculation (about 6 times), but I
need to stay at almost the same frequency for Timers (PPM read and Servos
commands).
What new MCU can I use ?
- Atmel have AT91SAM7 series: about 50Mips (only 3 times)
- others ?
Thanks for your suggestions.
Eric.
- [avr-gcc-list] 32-bits time, Eric Pasquier, 2005/10/12
- RE: [avr-gcc-list] 32-bits time, Gavin Jackson, 2005/10/12
- RE: [avr-gcc-list] 32-bits time, Eric Pasquier, 2005/10/12
- Re: [avr-gcc-list] 32-bits time, Galen Seitz, 2005/10/12
- Re: [avr-gcc-list] 32-bits time, Eric Pasquier, 2005/10/13
- [avr-gcc-list] After ATMega,
Eric Pasquier <=
- Re: [avr-gcc-list] After ATMega, Galen Seitz, 2005/10/13
- Re: [avr-gcc-list] After ATMega, Patrick Blanchard, 2005/10/13
- RE: [avr-gcc-list] After ATMega, Trampas, 2005/10/13
- RE: [avr-gcc-list] After ATMega, Patrick Blanchard, 2005/10/13
Re: [avr-gcc-list] 32-bits time, Dmitry K., 2005/10/13
RE: [avr-gcc-list] 32-bits time, Loveny Design, 2005/10/13