|
From: | Gilmore, Gerry |
Subject: | RE: [Bayonne-devel] E1 CTR4 Prompt / Time slot problem |
Date: | Fri, 21 Jan 2005 07:30:51 -0800 |
Julien, Gcdiag allows playing a prompt (and
recording a message) on a line. You just need to make sure to: A) call gcdiag with a voice resource on the command line…i.e.
gcdiag 1 1 isdn dxxxB1C1 B) Remember that the voice resource will be SCBus routed to the
channel specified on the command line. So, if you call gcdiag with channel 1 on
the command line, but a call comes in on channel 2, before playing the prompt,
you should use the menu option to “Change Active Channel”. This routes
the timeslots correctly. Gerry There are 10 kinds of people in the world,
those who understand binary and those who don't. Gerry Gilmore Field Applications Engineer Intel Corporation From:
address@hidden
[mailto:address@hidden On Behalf Of Julien Chavanton I am having strange problem on a server I have set in Sometime the I do not think it is an SCSA routing problem because we
would have noticed such problem before, but I am not completely sure. I have activated some debugging and apparently everything
looks fine. I have tried Dialogic & Globalcall drivers, same
behavior. I think this can be caused by the Telco switch “time
slot connection” because sometime I hear a prompt that is not on my
server, the D channel is always Receiving and sending information correctly. This is hard to debug, so I would just like to have
feed-back from people using Is there a test application I could use that would play
prompt on E1 ISDN so I can be sure Julien I have 2x DIALOGIC D/600 JCT 2E1 120 Configured as follow: [Genload - All Boards] LogFile=genload.log BLTAddress = D8000 Dialog/HD=YES BusType=SCBus SCBusClockMaster=AUTOMATIC SCBusClockMasterSource=AUTOMATIC PCMEncoding=ALAW ISABusWidth=16-BIT [Genload - ID 2] /* DCB/xxxSC */ [Genload - PCI ID 0] /* Dual T1/E1 PCI HD */ ParameterFile=ctr4.prm ParameterFile2=ctr4.prm ISDNProtocol=ctr4 ISDNProtocol2=ctr4 [Genload - PCI ID 1] /* Dual T1/E1 PCI HD */ ParameterFile=ctr4.prm ParameterFile2=ctr4.prm ISDNProtocol=ctr4 ISDNProtocol2=ctr4 |
[Prev in Thread] | Current Thread | [Next in Thread] |