[Bug binutils/14541] Wrong entry point computation using cross binutils linux amd64->arm-linux-gnueabihf

[eric.valette at free dot fr]

http://sourceware.org/bugzilla/show_bug.cgi?id=14541

--- Comment #6 from Eric Valette <eric.valette at free dot fr> 2012-10-29 
08:34:14 UTC ---
(In reply to comment #5)
> Hi Eric,
> 
>   Those are Thumb instructions.  Which explains why the bottom bit is set.
> 
>   I am not familiar with the ARM processor on the PI.  Maybe it is incapable 
> of
> executing these instructions ?  Perhaps you should specify the ARM processor
> type when you compile your program ?
> 
> Cheers
>   Nick

Yes but if you look at the config line, the processor has been specified when
building so thumb code should be off

-- 
Configure bugmail: http://sourceware.org/bugzilla/userprefs.cgi?tab=email
------- You are receiving this mail because: -------
You are on the CC list for the bug.