bug#54551: show-paren-mode inconsistency

[goncholden]

------- Original Message -------

On Friday, March 25th, 2022 at 4:20 PM, goncholden <goncholden@protonmail.com> 
wrote:

> ------- Original Message -------
>
> On Friday, March 25th, 2022 at 12:12 PM, Phil Sainty psainty@orcon.net.nz 
> wrote:
>
> > On 2022-03-25 11:48, goncholden wrote:
>
> > > Consider the following command
> > >   (setq initial-frame-alist '((width . 72) (height . 26)) ).
> > > Would be instructive that when one puts the cursor in the space
> > > between (width . 72) and (height . 26), the entire (width . 72)
> > > (height . 26) would be highlighted.

> > That wouldn't make any sense for show-paren-mode.

> > The cursor (point) is either between the ")" and " " characters, or
> > else between the " " and "(" characters. Those are the only two
> > possibilities, and in each case you would expect show-paren-mode to
> > highlight the adjacent expression (to the left or to the right of the
> > cursor, respectively).

> I use the block colouring of the cursor, meaning that your valid description
> in not so intuitive. Would it be possible to include a different 
> interpretation
> depending on the type of cursor display one is using?

> > > But (setq show-paren-when-point-inside-paren t) does not do that.

> > It's not documented as doing that, so there's not reason to expect
> > that it might.

> > I think you're looking for this library:
> >   https://www.emacswiki.org/emacs/HighlightSexp

> Will try it out and report back about it.

Is HighlightSexp only relevant for use with lisp-mode-hook and 
emacs-lisp-mode-hook ?