Re: bison segv under Cygwin 64 at fatal-signal.c:318

[Brian Inglis]

On 2021-09-18 10:15, Brian Inglis wrote:
> On 2021-09-18 09:10, Bruno Haible wrote:
> > Brian Inglis wrote:
> > > Respun and applied patch successfully to glm4/threadlib.m4.
> >
> > Did you regenerate the 'configure' script, and also do 'make distclean',
> > after patching threadlib.m4?
> >
> > Find attached a new 'testdir-thread' package. When you configure and
> > build it (with './configure -C' and NO explicit setting of 
> > gl_cv_have_weak,
> > then "make && make check"), does it work? I.e. does it complete with just
> > one test failure (test-raise)?
>
> No - how do you regenerate a configure script, and how do you do a make 
> distclean without a makefile generated?
> I've only dealt with autotools used by upstream packages.

Similarly, what would be required to patch threadlib.m4 and have it be 
used in the bison configure and build, to avoid the configure redefinition?

--
Take care. Thanks, Brian Inglis, Calgary, Alberta, Canada

This email may be disturbing to some readers as it contains
too much technical detail. Reader discretion is advised.
[Data in binary units and prefixes, physical quantities in SI.]