Re: Setting up eth-multiplexer in QEMU

[Sergiu Ivanov]

Hello,

On Sun, Jun 28, 2009 at 04:34:22PM +0800, Da Zheng wrote:
> Sergiu Ivanov wrote:
>> Do you suggest trying the following (where pfinet is the path to the
>> modified pfinet executable):
>>
>> # settrans -a /servers/socket/2 pfinet -i /dev/eth0 -a <ip> -g <ip> -m
>>   <mask>
>>
>> If so, it fails with pfinet: eth0: (ipc/mig) bad request message ID.
>>
>> Does it work for you?
>>   
> This is the most basic setup.
> I bet you didn't run devnode on /dev/eth0:-)

Nope, I didn't :-)

To get a more exact view of the problem, I stopped using apt-get
update for checking the connection. Instead, I use the following:

 # wget http://www.gigamonkeys.com/book/syntax-and-semantics.html

When I do

 # settrans -a /dev/eth0 devnode eth0

and then setup pfinet in the way I showed in my previous mail, wget
(quite quickly) connects to the site, downloads 2,576 bytes and then
stalls (always; I've checked this several times). When I try to run
the same wget command once again, it takes wget a long time to resolve
www.gigamonkeys.com and then it hangs trying to connect to the server.

Regards,
scolobb