Re: Debian Hurd tests on real hardware - network, IRQ issues

[Riccardo Mottola]

Hi!

more information on this laptop too. This one, as said, boots, but has 
no network. Also lspci under HURD hangs.

Under Linux, lspci shows:
00:00.0 Host bridge: VIA Technologies, Inc. VT8378 [KM400/A] Chipset 
Host Bridge
00:01.0 PCI bridge: VIA Technologies, Inc. VT8235 PCI Bridge
00:07.0 CardBus bridge: Texas Instruments PCI1410 PC card Cardbus 
Controller (rev 02)
00:08.0 FireWire (IEEE 1394): Texas Instruments TSB43AB21 
IEEE-1394a-2000 Controller (PHY/Link)
00:10.0 USB controller: VIA Technologies, Inc. VT82xx/62xx UHCI USB 1.1 
Controller (rev 80)
00:10.1 USB controller: VIA Technologies, Inc. VT82xx/62xx UHCI USB 1.1 
Controller (rev 80)
00:10.2 USB controller: VIA Technologies, Inc. VT82xx/62xx UHCI USB 1.1 
Controller (rev 80)
00:10.3 USB controller: VIA Technologies, Inc. USB 2.0 (rev 82)
00:11.0 ISA bridge: VIA Technologies, Inc. VT8235 ISA Bridge
00:11.1 IDE interface: VIA Technologies, Inc. 
VT82C586A/B/VT82C686/A/B/VT823x/A/C PIPC Bus Master IDE (rev 06)
00:11.5 Multimedia audio controller: VIA Technologies, Inc. 
VT8233/A/8235/8237 AC97 Audio Controller (rev 50)
00:11.6 Communication controller: VIA Technologies, Inc. AC'97 Modem 
Controller (rev 80)
00:12.0 Ethernet controller: VIA Technologies, Inc. VT6102/VT6103 
[Rhine-II] (rev 74)
01:00.0 VGA compatible controller: VIA Technologies, Inc. 
KM400/KN400/P4M800 [S3 UniChrome] (rev 01)

so, we have a VIA Rhine-III

dmesg shows this:
[    6.860096] via_rhine: v1.10-LK1.5.1 2010-10-09 Written by Donald Becker
[    6.940511] via-rhine 0000:00:12.0 eth0: VIA Rhine II at (ptrval), 
00:c0:9f:37:94:6b, IRQ 4
[    6.941301] via-rhine 0000:00:12.0 eth0: MII PHY found at address 1, 
status 0x7869 advertising 05e1 Link c5e1


Can this work under HURD?

Thanks,
Riccardo

Riccardo Mottola wrote:
> 2) An Acer Aspire with authentic AMD CPU and VIA Graphics usually 
> supported by the OpenChrome driver (which depending on the OS 
> distribution may be buggy, e.g. on Alpine Linux this computer is 
> unusable with X11)
> Here HURD "boots" then gets to DHCP and waits a looooong time (I 
> thought it was frozen, the first time I power-cycled) but eventually I 
> get to console. No network though.
> I guess that maybe the network card is not recongized or not configured?
> Lacking "dmesg" and "lspci" how can I investigate this more and give 
> you more information?
> Should I boot another OS and tell you the model information of this card?