bug-libtool
[Top][All Lists]
Advanced

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: libtool installation problem


From: Ambarish Mitra
Subject: RE: libtool installation problem
Date: Thu, 20 Jan 2005 14:42:09 +0530

Hi Ralf,
Thanks for your valuable response.

I will answer your specific questions now:
1) In all, it showed 4 tests failed: (I do not know, but tagdemo-make.test
appeared 3 times)
        -       demo-make.test
        -       tagdemo-make.test

2) I have run the command make check VERBOSE=x TESTS= ....
   and the output is inside the attached zip. (It reported errors)

The attached ZIP file contains all the outputs that you requested.
-       config.log
-       make check output
-       make check verbose output
-       libtool config output
-       libtool version output


Please guide. If you require any more information, please let me know, and I
shall pass those to you as soon as I can.

Regards,
Ambarish.


-----Original Message-----
From: Ralf Wildenhues [mailto:address@hidden
Sent: Tuesday, January 18, 2005 3:05 PM
To: Ambarish Mitra
Cc: address@hidden
Subject: Re: libtool installation problem


Hi Ambarish Mitra,

* Ambarish Mitra wrote on Tue, Jan 18, 2005 at 10:06:38AM CET:
>
> I downloaded the following package package from
> http://www.sunfreeware.com/indexsparc8.html
> PACKAGE: libtool-1.5.tar.gz
> <ftp://ftp.sunfreeware.com/pub/freeware/SOURCES/libtool-1.5.tar.gz>Source
> Code.
>
> I am using Solaris under Sparc and the version is 8.
> bash-2.03$ uname -a
> SunOS hostsun1 5.8 Generic_108528-21 sun4u sparc SUNW,Ultra-5_10
>
>
> I have done ./configure and it executed correctly. Then, the command make
> also executed correctly.
> But then make install or even make check fails.
>
> A snippet of the output of make check is pasted below.
> ====================================
> 4 of 101 tests failed
> (4 tests were not run)
> Please report to address@hidden
> ====================================

Please report the names of the the tests that failed and rerun them with
  make check VERBOSE=x TESTS='test1.test test2.test ...'
and report the output.

Please also post the output of the
  ./configure
run, and
  ./libtool --config
  ./libtool --version

You can bzip2 or gzip large output and attach it to your mail.

Thanks,
Ralf

Attachment: libtool_errors_solaris.zip
Description: Zip compressed data


reply via email to

[Prev in Thread] Current Thread [Next in Thread]