Each \stemBoth only reverts one \stemDown or \stemUp, so if you want
to revert both, you should do
\stemUp ... \stemBoth\stemDown ... \stemBoth
or \stemUp ... \stemDown ... \stemBoth\stemBoth
You didn't say if you use version 2.0 or 2.1. For 2.0, this is
described
at
http://lilypond.org/doc/v2.0/Documentation/user/out-www/lilypond/
Tuning-objects.html
for the more general case of setting properties (\stemUp and \StemDown
do \override and \stemBoth does a \revert).
For 2.1, read the new fancy chapter on Changing Defaults to find the
corresponding information.
/Mats
Will Oram wrote:
I had to force some stems to point up or down. I couldn't revert back
to automatic stemming after I was done, so everything after the
command is operating off \stemUp.
Here's where I first started observing it:
\stemUp a)[ \stemDown gsharp''']( \stemBoth a)[ < bsharp,, e >]( <
csharp e >)[ < bsharp, dsharp a' >]( < csharp e a >)[ gsharp]
Notice how \stemDown was the last override I used, but everything
appears \stemUp. I've called \stemBoth several times to see if change
in placement would help bring it back to autostemming. It didn't.
Will Oram
spamguy ^^AT^^ foxchange.com // william.oram ^^AT^^ cwru.edu // AIM
spamguy21
_______________________________________________
Bug-lilypond mailing list
address@hidden
http://mail.gnu.org/mailman/listinfo/bug-lilypond
--
=============================================
Mats Bengtsson
Signal Processing
Signals, Sensors and Systems
Royal Institute of Technology
SE-100 44 STOCKHOLM
Sweden
Phone: (+46) 8 790 8463
Fax: (+46) 8 790 7260
Email: address@hidden
WWW: http://www.s3.kth.se/~mabe
=============================================