Re: Solo vs. 1.

[Mats Bengtsson]

That's definitely very hard to find in the documentation (BUG!), but the
properties to set are called soloText and soloIIText, respectively.
Try

\set Staff.soloText = #"1."

   /Mats

Will Oram wrote:
> Is it possible to change the part combiner's autoinsertion of 
> 'Solo'/'Solo II'? Ideally I would rather have it '1.'/'2.', since I see 
> that more often than the former, and it takes up less space. Glancing 
> through the documentation, I don't see any obvious properties that would 
> do this.
>
> Will Oram
> spamguy ^^AT^^ foxchange.com // william.oram ^^AT^^ cwru.edu // AIM 
> spamguy21
>
>
>
> _______________________________________________
> lilypond-user mailing list
> address@hidden
> http://lists.gnu.org/mailman/listinfo/lilypond-user

--
=============================================
        Mats Bengtsson
        Signal Processing
        Signals, Sensors and Systems
        Royal Institute of Technology
        SE-100 44  STOCKHOLM
        Sweden
        Phone: (+46) 8 790 8463                         
        Fax:   (+46) 8 790 7260
        Email: address@hidden
        WWW: http://www.s3.kth.se/~mabe
=============================================