We have bought your CD-ROM "GNU Software for MS-Windows and MS-DOS".
Currently, I'm trying to port my Makefile written from NMake to GnuMake (V3.79.1.) using Windows NT system (and Windows 2000 later).
We have found the following troubles, and I suspect these are technical limitations. Please, could you confirm or infirm this, and how to workaround it.
1/ Executing the given command:
pl16cc -c -mdata-sec-.DSECT,mydata -mfile-io -fcall-used-r0 -fcall-used-r1 -O0 -g3 -Wall -emul -ID:\palm16\include -I. -ID:\Philips\Idk\Shl\Include Main.c -o Main.o Causes the following message:
make.exe: ***[Main.o] Error -1 Although the same command executed directly under DOS prompt is OK.
2/ When using a pathname or a filename exeeding 8.3 notation causes an error like file not found
Thank you for your help to workaround this.
Best regards.
Patrice.
\\\-|-///
( o o )
----------------------------------oOOo-(_)-oOOo----------------------------------------------
Patrice BOYRON..............................................Philips Semiconductors Sophia SAS
SoC Senior SW Engineer..............................BU Mobile Com./BL Cellular Infrastructure
......................................................................505, Route des Lucioles
Phone : +33 (0)4 92 96 12 82............................06560 Valbonne - Sophia Antipolis
Fax : +33 (0)4 92 96 12 72.......................................................FRANCE
Email : address@hidden
.oooO
----------------------------------- ( )-- Oooo. -------------------------------------------
\ ( ( )