[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: GNU/Hurd installation
From: |
Paul Smith |
Subject: |
Re: GNU/Hurd installation |
Date: |
Sun, 15 Jan 2023 15:59:09 -0500 |
User-agent: |
Evolution 3.46.3 (by Flathub.org) |
On Sun, 2023-01-15 at 21:31 +0100, Bruno Haible wrote:
> In my instructions for GNU/Hurd in 2020 I had noted
> Disable 'Nested paging', otherwise it DOES NOT BOOT!
>
> So, maybe it's worth looking at the main parameters of the VirtualBox VM:
> - General: Operating System: Other/Unknown
> - System: Motherboard: *Disable* all extended features (I/O APIC, EFI)
> - System: Processor: *Disable* all extended features (PAE/NX, Nested VT-x)
> [The latter is what I meant above.]
> - System: Paravirtualization Interface: You can try different values
> than 'Default'.
When I choose "Linux 2.4 (32-bit)" as the VM host type, those extended
features are disabled by default. However I went through the System
setting and turned off anything left such as hardware clock, got rid of
the audio card and USB, and I tried a few different paravirtualization
interface settings such as Minimal and Legacy but got the same results.
> Do you have other VirtualBox VMs that work?
Yes, I have other VirtualBox images that work fine.
- Re: GNU Make 4.4.0.90 on GNU/Hurd, Bruno Haible, 2023/01/15
- Re: GNU Make 4.4.0.90 on GNU/Hurd, Paul Smith, 2023/01/15
- Re: GNU/Hurd installation, Paul Smith, 2023/01/15
- Re: GNU/Hurd installation, Paul Smith, 2023/01/15
- Re: GNU/Hurd installation, Bruno Haible, 2023/01/15
- Re: GNU/Hurd installation, Paul Smith, 2023/01/16
- Re: GNU/Hurd installation, Paul Smith, 2023/01/18