|
From: | GKoch |
Subject: | [Dataexplorer-help] DATA EXPLORER by Winfried Bruegmann |
Date: | Sun, 27 Jul 2014 15:27:28 +0200 |
Hallo to the help desk, 1. Installed resp selected --HOTT Adapter---- as device. 2. Setup Vario 3. Imported 1 set of binary data from path 4. Fault Message occurred, “” The Receiver was setup in text mode to the configuration- no sensor values has been logged on In German: „““Sender wurde in den Textmodus zur Konfiguration geschaltet , es werden dabei keine Sensorwerte gelogged.““ 5. From a previous installation of the program i got correct results, i.e. binary data have been sucessfully loaded And graph resp curves show up on display, printouts could be made. All was just fine. 6. Program always switches to RECEIVER, instead staying on VARIO why does this happen ?? THANK YOU and best regards Gustav. W. Koch |
[Prev in Thread] | Current Thread | [Next in Thread] |