[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
add-symbol-file prompt disappears
From: |
Adam Steineck |
Subject: |
add-symbol-file prompt disappears |
Date: |
Sun, 3 Dec 2006 13:03:36 +0100 |
ODDITY:
the
(y/n) prompt does not appear after invoking
add-symbol-file.
SCENARIO:
I am
attempting to debug via a gdb-remote server and using an inferior debugger. I
thus invoke ddd like this:
ddd
--debugger my_gdb
DDD
then dutifully starts.
Prior
to connecting to the target, I must load the symbol table with the
"add-symbol-file" command with address offsets.
Like
so:
add-symbol-file module.ko 0xe11a4000 -s .bss 0xe11c5c0c
-s .data 0xe11c5940
Usually, I would be presented with a (y/n) prompt, but now I get nothing
but the (gdb) prompt appears and no more.
If I
invoke my_gdb directly, I can perform the add-symbol-file operation and
everything is fine. The debugger launches and works as
advertised.
OWN
SUGGESTION
I will
also try to put the add-symbol-file in a batch command to see if this gets
around the problem tomorrow.
BR
Adam
- add-symbol-file prompt disappears,
Adam Steineck <=