Testing GDB using Dejagnu

[Venkatesan Jeevanandam]

Hi,

 

I am supposed to test a custom debugger (xxx-gdb) which is ported from gdb. I need to use Dejagnu testsuite in order to test the debugger (i.e. xxx-gdb). 

 

The host being used is a x86 machine and the executable is to be run on a remote non-x86 machine.  (As of now, I’m  executing it on a simulator, not on the actual hardware).  So, I need to do a remote debug session.  In other words, I have to test the xxx-gdb, where the host is x86 and target is non-x86 machine.

 

So, can I use Dejagnu testsuite to test the custom gdb (xxx-gdb)??

 

Regards,

Ravi.

 

 

DISCLAIMER:

This message (including attachment if any) is confidential and may be privileged. If you have received this message by mistake please notify the sender by return e-mail and delete this message from your system. Any unauthorized use or dissemination of this message in whole or in part is strictly prohibited.

E-mail may contain viruses. Before opening attachments please check them for viruses and defects. While MindTree Consulting Limited (MindTree) has put in place checks to minimize the risks, MindTree will not be responsible for any viruses or defects or any forwarded attachments emanating either from within MindTree or outside.

Please note that e-mails are susceptible to change and MindTree shall not be liable for any improper, untimely or incomplete transmission.

MindTree reserves the right to monitor and review the content of all messages sent to or from MindTree e-mail address. Messages sent to or from this e-mail address may be stored on the MindTree e-mail system or else where.