inconsistent results.

[Ravishankar BV.]

Hi,

 

I’m using dejagnu framework on GNU gdb suite to test a custom debugger.

 

I’m able to debug successfully using the framework and suite.  (The debugging takes place here using remote connection and is also successful)

 

However, I observe that the PASS/FAIL results are not consistent when I re-run the tests again.  I suspect this could be due to timeout issues. 

 

Can anyone let me know the reasons for inconsistent behavior?  What are the things to be taken care of while “remote debugging” using the suite?

 

Thanks in advance,

 

Ravi.

DISCLAIMER:

This message (including attachment if any) is confidential and may be privileged. If you have received this message by mistake please notify the sender by return e-mail and delete this message from your system. Any unauthorized use or dissemination of this message in whole or in part is strictly prohibited.

E-mail may contain viruses. Before opening attachments please check them for viruses and defects. While MindTree Limited (MindTree) has put in place checks to minimize the risks, MindTree will not be responsible for any viruses or defects or any forwarded attachments emanating either from within MindTree or outside.

Please note that e-mails are susceptible to change and MindTree shall not be liable for any improper, untimely or incomplete transmission.

MindTree reserves the right to monitor and review the content of all messages sent to or from MindTree e-mail address. Messages sent to or from this e-mail address may be stored on the MindTree e-mail system or else where.