|
From: | Steven Rubin |
Subject: | Re: How to adjust size of n-well and p-well in cmos |
Date: | Wed, 29 May 2002 17:21:44 -0700 |
I check in the cell library, the size of n-well and p-well( yellow stripe and brown stripe) are bigger than specified in the component list. How do you adjust it?
There are extra nodes (called "pure layer nodes") that carry only a single layer of material. I suspect that such nodes exist in those facets. You can select them and change their size. Note that these nodes are sometimes set to be "hard to select" so that they don't interfere with normal editing. To select them, you must use the "special select" button sequence (varies with platform). See the manual for more information.
-Steven Rubin
[Prev in Thread] | Current Thread | [Next in Thread] |