[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Discuss-gnuradio] 3 out of 4 channels not working?
From: |
Ben Gelb |
Subject: |
Re: [Discuss-gnuradio] 3 out of 4 channels not working? |
Date: |
Sun, 19 Oct 2003 01:55:56 -0400 |
The calibrate routine runs without complaining.
Not sure what you mean by test code. There is a section of InstaCal that
is a test procedure for the analog inputs. This is what I used to
determine the behavior I outlined.
I will see what MCC has to say.
-Ben
On Sat, 2003-10-18 at 17:01, Eric Blossom wrote:
> On Sat, Oct 18, 2003 at 04:30:51PM -0400, Ben Gelb wrote:
> > I received my Measurement Computing board yesterday. I've taken it out
> > of the box and installed it and it seems that channels 0, 1, and 3 do
> > not function.
> >
> > When in high impedance mode, they always measure +5V and in 50 ohm mode
> > they measure 0V (I determined this by running the InstaCal software).
> > It's almost as if the ADC is working but the BNC connectors aren't
> > physically connected to the board. Very weird. I'm putting in a support
> > request to MCC, but I wanted to know if anyone on the list perhaps knows
> > something simple I'm missing.
> >
> > Channel 2 on the other hand produced a very nice plot when I ran
> > adc3_fftavg and connected my G5RV antenna to it. Very cool!
> >
> > -Ben
>
> Sorry, I haven't seen anything like this.
>
> Does the board calibrate OK under windows?
> Does the board pass the test code in the windows software?
>
> Eric
--
Ben Gelb <address@hidden>