Shweta,
You are using a wi-fi antenna (2.4 / 5.8ghz) for
29mhz band? If it is true, use a ghz antenna on the mhz range as the same as
nothing, because the wavelength of 2.4ghz are 13cm and the wavelenght of 29 are
10meters, and if the dipole have some harpin, gamma math or some impedance
adaptor, on 29mhz as the same as to do a shortcircuit, and you can damage the
board.
Iban
----- Original Message -----
Sent: Wednesday, August 10, 2005 9:06
AM
Subject: Re: [Discuss-gnuradio] Re: Noise
while executing USRP examples
Hii Eric,
1)As suggested by Matt ,we have purchased the Antennas
(Specifications again for reference).
2) Now Can we change the
frequency range for the below specified examples fsk_tx.py , fsk_rx.py
and nbfm_ptt_quick_and_dirty.py other than 29Mhz ?
3) Since we
have already purchased the antenna's , is there any way that, with minimal
modifications we can use the same Antennas?
Please provide some
solution on the same.
Antenna specifications:
1. Electrical
Characteristics:
Operating Frequency 2.4~2.5 & 4.9
& 5.15~5.35 & 5.725~5.85 GHz Antenna Type:
Dipole Polarization Type : Linear Type
of Radiation: Toroidal Peak Gain 2.0 dBi Typical For 2
G 4.0 dBi Typical For 5 G Impedance: 50 Ohm
nominal
V.S.W.R. 2.0:1 Max.
2.
Mechanical Characteristics
Swivel : 90
degrees Connector: SMA(M) Core:
N/A Regards, Shweta
On Wed, 10 Aug 2005 Eric Blossom
wrote : >On Wed, Aug 10, 2005 at 10:34:32AM +0530, Arora_Amit
wrote: > > > > 1) We
are running the USRP examples on USRP board fsk_tx.py > > and
fsk_rx.py on one PC. During execution we are receiving too much of >
> noise, what might be the reason?.any solution? > > > >
2) Can we run both fsk_tx.py and
fsk_rx.py simultaneously > > on the same PC or do we need to run them
on two different PC's ? > > > > 3)
While running nbfm_ptt_quick_and_dirty.py we are >
> receiving lot of noise. Please provide some solution? > >Matt
and I will be sorting out the Tx/Rx example sometime before we >release
2.6. > > > 4) As
suggested in the USRP document, we are using the > > antenna with
following specifications: > >An antenna tuned for 5 GHz is not
going to work well for Tx and Rx >taking place at 29
MHz... > >Eric > > >_______________________________________________ >Discuss-gnuradio
mailing
list >address@hidden >http://lists.gnu.org/mailman/listinfo/discuss-gnuradio
_______________________________________________ Discuss-gnuradio
mailing
list address@hidden http://lists.gnu.org/mailman/listinfo/discuss-gnuradio
|