[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Discuss-gnuradio] BBN code-Failed to set Tx frequency to 2.4G
From: |
DiX |
Subject: |
Re: [Discuss-gnuradio] BBN code-Failed to set Tx frequency to 2.4G |
Date: |
Thu, 24 Jan 2008 19:40:19 -0800 (PST) |
"It seems that BBN codes doesnot work with MIMO dautherboards" ?
At least the rx path should work. I use the wireless card to generate the
packet instead of using bbn tx path. In fact I don't think I ever used the
USRP to generate any well shaped .11b packets.
-Di
Mohammad Hamed Firooz wrote:
>
>
> Hi
>
> I've tried to use BBN code to transmit 802.11 packets by using RFX2400
> dautherboard. When I run "bbn_80211b_tx.py" I get the following message:
>
> Using TX d'board A: Flex 2400 Tx MIMO B
>>>> gr_fir_ccf: using SSE
> spb: 8
> interp: 32
> Failed to set Tx frequency to 2.4G
>
> I went through the code but I could not figure out what the problem
> is. I found this message in mailing archive:
>
> http://lists.gnu.org/archive/html/discuss-gnuradio/2007-07/msg00010.html
>
> It seems that BBN codes doesnot work with MIMO dautherboards, has
> anybody else had the same problem? Is there anybody who can run BBN
> transmitter code using MIMO RFX2400 daughterboard?
>
> regards,
> hamed
>
>
> _______________________________________________
> Discuss-gnuradio mailing list
> address@hidden
> http://lists.gnu.org/mailman/listinfo/discuss-gnuradio
>
>
--
View this message in context:
http://www.nabble.com/BBN-code-Failed-to-set-Tx-frequency-to-2.4G-tp15077349p15080422.html
Sent from the GnuRadio mailing list archive at Nabble.com.