[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[Discuss-gnuradio] Re: dbsrx question
From: |
Dlaniger Repooc |
Subject: |
[Discuss-gnuradio] Re: dbsrx question |
Date: |
Tue, 20 Jan 2009 21:03:55 +0100 |
David Caruth wrote:
> Hi All.
>
> I've been trying to use the DBSRX daughterboard in slot A but am
> running into some trouble while reading the status bytes of the Maxim
> chip via i2c. The code I'm using to control the USRP is written in
> Visual C++ 2005, and I've been able to talk to the TVRX daughterboard
> with no problems. I added the c++ code to mimic the set_freq, set_gain,
> etc... commands in db_dbs_rx.py, and seem to be able to adjust the gain
> and bandwidth for the Maxim chip ok. The problem comes when I try to
> use the set_freq command, which does a read_i2c which returns the two
> status bytes as ints. I've done a side-by-side comparison with the
> python script running on the same machine under Windows XP where I
> monitor the register number and the value as commands are sent, and I
> see my code executing exactly the same as the python script usrp_fft.py,
> except that the status bytes returned by my code are 0, 127 as opposed
> to the returned bytes in the python code of 8, 127. I don't think I'm
> doing
> anything dumb with char to int conversions either in my code. Because
> I get 0 for the first byte all the time, my while loop to set the
> adc_val continues until it returns false, and the frequency never gets
> set. The python script usrp_fft.py runs with no problems and I can
> set_freq just fine. I have searched this forum for i2c errors and dbs
> problems, but have not found anything like my problem. I'm sure I have
> the correct i2c address set as well. Any suggestions? Please don't
> suggest that I just use the python script... :)
>
> Thanks a lot!
David,
I am trying to setup USRP w/RFX2400 db to work in visual C++.
Would I be able to get a copy of your Visual C++ code to use as a
guidline on what to do?
Thanks
--
Posted via http://www.ruby-forum.com/.
[Prev in Thread] |
Current Thread |
[Next in Thread] |
- [Discuss-gnuradio] Re: dbsrx question,
Dlaniger Repooc <=