[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Discuss-gnuradio] USRP2 &DBSRX testing
From: |
Matt Ettus |
Subject: |
Re: [Discuss-gnuradio] USRP2 &DBSRX testing |
Date: |
Tue, 03 Mar 2009 11:14:40 -0800 |
User-agent: |
Thunderbird 2.0.0.19 (X11/20090105) |
Bob Taylor wrote:
Matt,
I'm also attempting to get a DBSRX working in a USRP2, and am looking
forward to obtaining the instructions and code. Any chance they're already
available somewhere and I missed them?
Sorry for the delay.
This will only work if you have a DBSRX which says "Rev 2.2". This
should be most units from 2007, and everything from 2008 or 2009. It
will not work with older DBSRX boards. For those, there is no way to
use them with the USRP2.
There are 2 steps to the process:
1 - Put the DBSRX on a USRP1 on Side A, connect it to a computer, and
run the command:
burn-db-eeprom -A --force -t dbsrx2
2 - Remove R193 (which is 10 ohms, 0603 size) and put it on R194, which
is empty. This is made somewhat more complicated by the fact that the
silkscreen is not clear in that area. R193 is on the back, immediately
below the large beige connector, J2. R194 is just below, and to the
left of R193. The silkscreen for R193 is ok, but for R194, it is upside
down, and partially cut off.
If you lose R193, you can use anything from 0 to 10 ohms there.
Matt
- Re: [Discuss-gnuradio] USRP2 &DBSRX testing,
Matt Ettus <=