[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Discuss-gnuradio] Using scope in benchmark_tx to see signals before
From: |
udadidd |
Subject: |
Re: [Discuss-gnuradio] Using scope in benchmark_tx to see signals before and after modulation |
Date: |
Tue, 11 Aug 2009 14:19:02 -0700 (PDT) |
Sorry, Thats PORT B ALREADY in USE
udadidd wrote:
>
> sure i can do that.
> But my connections are like this.....
>
> self.connect(module A, module B, file_sink.1)
> self.connect(module A,module B, module C)
>
> self.connect (module C, module D, file_sink.2 )
> self.connect (module C, module D, module E)
>
>
> So now if i try to insert file in between my connections, it says, the
> port C already in use!!
> So is there a way i can tap the data at these points?
>
>
>
>
>
> Eric Blossom wrote:
>>
>> On Tue, Aug 11, 2009 at 08:59:23AM -0700, udadidd wrote:
>>>
>>> hi
>>> i want to see the signals on the scope before and after modulation. but
>>> the
>>> transmit_path.py use hier_block2 and benchmark_tx use top_block. can any
>>> one
>>> kindly help on where should i go ahead and make changes?
>>
>> May I suggest logging the data to a file using gr.file_sink(...)
>> then examining it using octave, scipy, ...
>>
>> Eric
>>
>>
>> _______________________________________________
>> Discuss-gnuradio mailing list
>> address@hidden
>> http://lists.gnu.org/mailman/listinfo/discuss-gnuradio
>>
>>
>
>
--
View this message in context:
http://www.nabble.com/Is-it-possible-to-change-ADC-DAC-rates--tp24178434p24925956.html
Sent from the GnuRadio mailing list archive at Nabble.com.