[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Discuss-gnuradio] Gain Range error
From: |
Eric Schneider |
Subject: |
Re: [Discuss-gnuradio] Gain Range error |
Date: |
Sat, 16 Jan 2010 11:46:39 -0700 |
Just out of curiosity, was there a design decision made to not use the
DAC PGAs to adjust Tx gain?
On Sat, 2010-01-16 at 09:08 -0800, Josh Blum wrote:
> On 01/16/2010 01:36 AM, amarnath alapati wrote:
> > hi friends,
> > When I tried to print the Transmitter gain range by the following
> > commands,
> > The output is as followss,
> >
> > address@hidden digital]# python benchmark_tx.py -f 2412M
> > --show-tx-gain-range
> >>>> gr_fir_fff: using SSE
> > Tx Gain Range: minimum = 0, maximum = 0, step size = 1
> >
> > 1) Why is the gain Minimum and Maximum showing the same 0?
>
> The daughter board which you use, has no configurable transmit gain.
>
> > 2) How to control the transmit power ? Should I use the --amplitude command?
>
> This is the amplitude of the digital samples going into the usrp2
> device. You can use higher amplitudes, but be aware that if the
> amplitude is too high, the samples will clip in the fpga dsp. The
> maximum is 1.0 (this will clip).
>
> > 3) can some one breif me on the controlling of transmitter power issue?
> >
>
> Use a mix of digital signal amplitude and programmable hardware gain to
> control the transmit power within the usrp. In this case of your
> daughter board, there is no configurable hardware gain
>
> -Josh
>
>
> _______________________________________________
> Discuss-gnuradio mailing list
> address@hidden
> http://lists.gnu.org/mailman/listinfo/discuss-gnuradio