[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[Discuss-gnuradio] usrp stopped working
From: |
Reynaldo Baquerizo |
Subject: |
[Discuss-gnuradio] usrp stopped working |
Date: |
Thu, 28 Jan 2010 22:48:35 -0500 |
Dear all,
My USRP has been working great until recently. Today, I tried testing with
usrp_benchmark.py and got this, but not always. I tested it with gnuradio 3.1.3
and gnuradio 3.2.2 and got the same results.
Testing 2MB/sec... usrp_open_interface:usb_set_alt_interface: failed
could not set alt intf 0/0: Protocol error
open_nth_cmd_interface: open_cmd_interface failed
usrp: failed to load firmware /usr/local/share/usrp/rev4/std.ihx.
Traceback (most recent call last):
File "usrp_benchmark_usb.py", line 106, in <module>
main ()
File "usrp_benchmark_usb.py", line 96, in main
ok = run_test (rate, verbose)
File "usrp_benchmark_usb.py", line 63, in run_test
usrp_tx = usrp.sink_s (0, tx_interp)
File "/usr/local/lib/python2.5/site-packages/gnuradio/usrp.py", line 232,
in __init__
fpga_filename, firmware_filename)
File "/usr/local/lib/python2.5/site-packages/gnuradio/usrp1.py", line 946,
in sink_s
return _usrp1.sink_s(*args)
RuntimeError: can't open usrp1
The boards still blink, sometimes when I power it on it doesn't blink,
sometimes after a while both leds are steady.
I would appreciate any hints to find out if I accidentally damage it.
Regards,
--
Reynaldo
--
[Prev in Thread] |
Current Thread |
[Next in Thread] |
- [Discuss-gnuradio] usrp stopped working,
Reynaldo Baquerizo <=