Re: [Discuss-gnuradio] Testing USRP with WBX

[Matthew Robert]

Awesome, thanks guys, I built the current git version and it works perfectly.

Regards,
Matt

On Fri, Feb 5, 2010 at 4:19 PM, Matt Ettus <address@hidden> wrote:
>
>
> Yes, the releases don't support the WBX, you need git.
>
> Matt
>
> On 02/04/2010 09:04 PM, Timothy Newman wrote:
>>
>> I believe you need to use the current source from the git tree, not the
>> 3.2.2 tarball.
>>
>> Tim
>>
>> Matthew Robert wrote:
>>>
>>> Hi List,
>>>
>>> I have a USRP1 with a WBX in the B side and a DBSRX in the A side. I
>>> have just done a fresh install of the stable tarball (3.2.2) and I ran
>>> the usrper load_standard_bits. The USRP1 serial number is in the
>>> 3700-3800 range so I believe it is compatible with the WBX.
>>>
>>> When I run usrp_benchmark I get the following error:-
>>>
>>>
>>>
>>> Testing 32MB/sec...
>>> Warning: Treating daughterboard with invalid EEPROM contents as if it
>>> were a "Basic Tx."
>>> Warning: This is almost certainly wrong... Use appropriate
>>> burn-*-eeprom utility.
>>>
>>>
>>> Warning: Treating daughterboard with invalid EEPROM contents as if it
>>> were a "Basic Rx."
>>> Warning: This is almost certainly wrong... Use appropriate
>>> burn-*-eeprom utility.
>>>
>>> uUusb_throughput = 32M
>>> ntotal = 16000000
>>> nright = 15988058
>>> runlength = 15988058
>>> delta = 11942
>>> OK
>>> Max USB/USRP throughput = 32MB/sec
>>>
>>>
>>> Is there something more I need to do to make this work?
>>>
>>> Cheers,
>>> Matt
>>>
>>>
>>> _______________________________________________
>>> Discuss-gnuradio mailing list
>>> address@hidden
>>> http://lists.gnu.org/mailman/listinfo/discuss-gnuradio
>>
>>
>>
>> _______________________________________________
>> Discuss-gnuradio mailing list
>> address@hidden
>> http://lists.gnu.org/mailman/listinfo/discuss-gnuradio
>
>