[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[Discuss-gnuradio] Full duplex with RFX2400 on USRP2
From: |
加藤義也 |
Subject: |
[Discuss-gnuradio] Full duplex with RFX2400 on USRP2 |
Date: |
Thu, 18 Mar 2010 17:28:35 +0900 |
Hello gnu-radio friends.
I would like to realize RFX2400 full duplex configuration.
I am using RFX2400 on USRP2 and tried to transmit and receive(fft.py at the same time.
But I got unstable spectrum for both TX/RX.
Here is the video
And configuration is as below.
-------------------------------------
U-+RFX2400(TX/RX)+----SpectrumAnalyzer.
S |
R |
P |
2-+RFX2400( RX2 )+----Signal Source.
-------------------------------------
I found RFX2400 schematics from below URL
And I believe this situation is because of U202 / U209 to swith state cycles
A->B and B->A in very often.
I would like to use both U202 / U209 to fix the swith state always to "A".
Would you please let me know how to make U202(RFswitch) / U209(RFswitch) fix to A state.
(say "full-duplex mode")
Do I still need to hardwire fix the RF-swith to A? if there is no FPGA image / firmware available to fix them.
Thank you very much in advance.
Best Regards.
--
--
株式会社テレマン・コミュニケーションズ
加藤義也<address@hidden>
121-0012 東京都足立区青井6-8-11
電話:03-5888-7300 FAX:03-5888-7301
Telemann Communications Co., Ltd.
TEL:+(81)-3-5888-7300 FAX:+(81)-3-5888-7301
Board Member / Technical Director
Yoshiya Kato <address@hidden>
- [Discuss-gnuradio] Full duplex with RFX2400 on USRP2,
加藤義也 <=