discuss-gnuradio
[Top][All Lists]
Advanced

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Discuss-gnuradio] UHD bringup help


From: bobb
Subject: Re: [Discuss-gnuradio] UHD bringup help
Date: Thu, 26 Aug 2010 20:37:35 +0000

Josh,

  I did the firmware/FPGA image. That appeared to go well.

  Your first suggestion (net configuration) was the culprit. An ifconfig 
command with the appropriate parameters appears to have done the trick (now I 
can see the device using uhd_find_devices (no args)).

  Thanks much,

  --Bob

>-----Original Message-----
>From: Josh Blum [mailto:address@hidden
>Sent: Thursday, August 26, 2010 04:19 PM
>To: address@hidden
>Subject: Re: [Discuss-gnuradio] UHD bringup help
>
>did you burn firmware as well? its possible that you only write the fpga
>image with old firmware onto the sd card and to see the results as you
>did. Have you tried a serial dongle and looked at the debug output,
>there should be stuff about ip addresses/
>
>-josh
>
>On 08/26/2010 11:59 AM, address@hidden wrote:
>> Philip,
>>
>>    Thanks, but that didn't seem to help, still getting the same thing.
>>
>>    Disabled firewall via Linux GUI (System:Administration:Firewall) (says 
>> "Firewall is disabled" (in red) at the bottom of the panel).
>>
>>    --Bob
>>
>>> -----Original Message-----
>>> From: Philip Balister [mailto:address@hidden
>>> Sent: Thursday, August 26, 2010 02:34 PM
>>> To: address@hidden
>>> Subject: Re: [Discuss-gnuradio] UHD bringup help
>>>
>>> Wild guess, firewall?
>>>
>>> Philip
>>>
>>> On 08/26/2010 02:24 PM, address@hidden wrote:
>>>>
>>>> We've decided it's time to "bite the bullet" and try migrating to UHD.
>>>>
>>>> I flashed a couple of SD cards with the latest image 
>>>> (UHD-images-20100817.012137.230368d-Linux). That seemed to go well.
>>>>
>>>> Then I booted up 2 U2's... I got 3 LEDS on (B, D&   F) + I didn't notice 
>>>> all the LEDs coming on at first (like with the old firmware). Is this 
>>>> normal? I'm used to seeing just D&   F - I was hoping B might indicate UHD 
>>>> firmware, but...
>>>>
>>>> Undaunted I tried:
>>>>
>>>> $ ./uhd_find_devices
>>>> No UHD Devices Found
>>>> $ uhd_find_devices --args addr=192.168.10.2
>>>> No UHD Devices Found
>>>>
>>>> I put back the original SD cards and starting writing this email...
>>>>
>>>> Any suggestions would GREATLY appreciated.
>>>>
>>>>     Thanks!
>>>>
>>>>     --Bob
>>>>
>>>>
>>>>
>>>>
>>>> _______________________________________________
>>>> Discuss-gnuradio mailing list
>>>> address@hidden
>>>> http://lists.gnu.org/mailman/listinfo/discuss-gnuradio
>>>>
>>>
>>
>>
>>
>>
>>
>> _______________________________________________
>> Discuss-gnuradio mailing list
>> address@hidden
>> http://lists.gnu.org/mailman/listinfo/discuss-gnuradio
>





reply via email to

[Prev in Thread] Current Thread [Next in Thread]