|
From: | Marcus D. Leech |
Subject: | Re: [Discuss-gnuradio] USRP2-FLEX2400 Transmit and Receive problems |
Date: | Wed, 01 Sep 2010 15:08:53 -0400 |
User-agent: | Mozilla/5.0 (X11; U; Linux i686; en-US; rv:1.9.1.11) Gecko/20100720 Fedora/3.0.6-1.fc12 Thunderbird/3.0.6 |
On 09/01/2010 12:51 PM, Jason Abele wrote:
So, Jason, is this because the older FLEX-series boards used an on-board clock that is *different* than the one supplied by the USRP2, and the driver code (either Classic or UHD) assumes a different clock rate than the one that was previously on-board, and thusI'll need to do some re-soldering and burn-db-eeprom with USRP1 and hopefully this should fix the problem: http://gnuradio.org/redmine/wiki/1/USRPClockingNotesAlso, since you use UHD, you can change the daughterboard ID of a daughterboard on a USRP2 from your host PC using: <prefix>/share/uhd/utils/uhd_burn_db_eeprom An example of changing the DBID for a DBSRX is show here: http://www.ettus.com/uhd_docs/manual/html/dboards.html#id1 Jason
is mis-programming the PLL?If the two clocks are the same frequency, then I don't understand why changing from "clock supplied on-board" to "clock supplied by USRP2" would "fix" the problem.
Inquiring minds want to know... -- Marcus Leech Principal Investigator Shirleys Bay Radio Astronomy Consortium http://www.sbrac.org
[Prev in Thread] | Current Thread | [Next in Thread] |