On 09/14/2010 01:56 PM, Marc Epard wrote:
I've been attempting to do a full duplex send/recv using UHD on a USRP2 with an XCVR2450.
The major problem I had was that issue_stream_cmd nearly always resulted in a runtime error of "usrp2 no control response". It worked fine if I transmitted w/o receiving or received w/o transmitting. The same code also worked when using a 2nd USRP2 for receiving.
After a session with Wireshark and the UHD host source, I had my "Well, duh" moment. When you call send, the data starts streaming to the USRP2 right away -- even if you specify a timestamp in the future. The USRP2 starts sending back PAUSE frames almost immediately, which throttles not only additional send data, but also any commands to the control port.
The solution is to call issue_stream_cmd first (and start the recv thread), then start the send thread. This was simple enough in my app because I was specifying start times in the future anyway. It does prevent a method I was going to use on a WBX where I start the send thread once and scan through several receive frequencies before stoping the send thread.
Perhaps most of you knew about this gotcha already, but I hope this will help someone else who encounters the problem. Anyway, it was fun investigating and I learned a lot more about the UHD host code and protocols
-Marc
_______________________________________________
Discuss-gnuradio mailing list
address@hidden
http://lists.gnu.org/mailman/listinfo/discuss-gnuradio
_______________________________________________
Discuss-gnuradio mailing list
address@hidden
http://lists.gnu.org/mailman/listinfo/discuss-gnuradio