[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Discuss-gnuradio] UHD with XCVR?
From: |
Marius |
Subject: |
Re: [Discuss-gnuradio] UHD with XCVR? |
Date: |
Sun, 31 Jul 2011 22:32:25 +0200 |
Hi Josh,
> There was some shuffling around with the uhd master branch for the 3.2
> releases. If you are running off the master, can you rebuild from the
> latest master (fc349d30507620baca935e75e68a9554b40d427c) and load the
> latest images (firmware and FPGA)
> http://www.ettus.com/downloads/uhd_releases/master_images/ I think that
> will solve your problem.
Loading the released binary images did not solve my problem. I tried them all.
The problem persists in the same way I described it.
Rebuilding the usrp2 firmware is with an issue too:
make[5]: Entering directory
`/home/marius/gnuradio_build/gnuradio/usrp/host/swig'
make[5]: *** No rule to make target `/usr/include/fpga_regs_common.h',
needed by `usrp_prims.py'. Stop.
make[5]: Leaving directory `/home/marius/gnuradio_build/gnuradio/usrp/host/swig'
make[4]: *** [all-recursive] Error 1
make[4]: Leaving directory `/home/marius/gnuradio_build/gnuradio/usrp/host'
make[3]: *** [all-recursive] Error 1
make[3]: Leaving directory `/home/marius/gnuradio_build/gnuradio/usrp'
make[2]: *** [all] Error 2
make[2]: Leaving directory `/home/marius/gnuradio_build/gnuradio/usrp'
make[1]: *** [all-recursive] Error 1
make[1]: Leaving directory `/home/marius/gnuradio_build/gnuradio'
make: *** [all] Error 2
I'm not sure right now how to solve this...
Thanks for the points so far.
Best,
Marius