Thanks a lot for your reply Marcus! The thing is, I have been
running the gnuradio on E100 and there is no graphical support, so I
was wondering if there is another way to conform reception? Or
should I run
the gnuradio on the PC and get data from E100? Thanks.
On 09/14/2011 07:35 PM, ziyang wrote:
Hello
everyone,
I'm new to gnuradio & usrp devices. I tried to update the
ucla_zigbee_phy examples "cc2420_txtest.py" and "cc2420_rxtest.py"
to work with UHD (see attachments), then I ran the codes
separately on two E100 devices but cannot get any packet from the
receiver. To find out the problem, I connected a vector sink
directly to the uhd.usrp_source in the receiver. Then I got some
data but it seems nothing came from the transmitter side, because
even if I do not run the transmitter, the values of the collected
data does not change much, most of which are smaller than 0.01.
I have been using the E100 boards and RFX2400 daughter boards,
with UHD image 003.002.001.
The options for the usrp devices are:
center frequency: 2.475 GHz
sample rate: 200 000
Now I got confused by what happened, could someone have a look at
my codes and give me a tip about what might be the problem?
Thanks in advance,
Terry
_______________________________________________
Discuss-gnuradio mailing list
address@hidden
https://lists.gnu.org/mailman/listinfo/discuss-gnuradio
|