./tunnel.py -f 2.42G -c 50It didn't work, both the transmitter and the receiver only showed TX without RX and it didn't response when I ping.
But when I set the freq to 300M (which is not supported by daughter boards)
./tunnel.py -f 300M -c 50
It worked and both the transmitter and receiver showed TX and RX and response when I ping. And it also gave the following warning:
UHD Warning:
The hardware does not support the requested RX frequency:
Target frequency: 300.0000000 MHz
Actual frequency: 2400.0000000 MHz
UHD Warning:
The hardware does not support the requested TX frequency:
Target frequency: 300.0000000 MHz
Actual frequency: 4500.0000000 MHz
Clearly the 4500MHz is not the real TX frequency. What is that?
--
Regards,
Weixian Zhou