Re: [Discuss-gnuradio] Fw: Using two daughter boards in USRP1.

[Josh Blum]

Can we use one daughter card as sender
> and the other as receiver, rather using two USRP for this purpose.
> 

USRP1 may have 2 transmitter and 2 receiver frontends.

You may transmit from either frontend and receive from either frontend.
Any combination should be OK.

Cheers,
-josh


> Best Regards.
> 
> ----- Forwarded Message ----- From: Sajjad Safdar
> <address@hidden> To: "address@hidden"
> <address@hidden> Sent: Thursday, September 20, 2012 6:46
> PM Subject: Using two daughter boards in USRP1.
> 
> 
> Hello, I am trying to use two daughter boards in one USRP1. I have
> RFX400 on one side A and TVRX on side B. When i try to use two
> seprate terminals to test the daughter cards in such a way that
> RFX400 is transmitting and TVRX is recieving on the same USRP1 device
> using uhd_fft and benchmark_tx.py for sending data, but this does not
> work. when i run uhd_fft the scanning works but when i try to run
> benchmark_tx in another window, it gives some error tha can not find
> usrp device, how can i make it possible to work with both cards on
> the same device rather than using two different devices.
> 
> 
> 
> _______________________________________________ Discuss-gnuradio
> mailing list address@hidden 
> https://lists.gnu.org/mailman/listinfo/discuss-gnuradio
>