[Discuss-gnuradio] USRP N200 not being identified by the host running Suse

[Rahman, Muhammad Mahboob Ur]

All,

When I connect my USRP N200 to a PC running Suse, run ifconfig eth0 192.168.10.1 command, and then run command uhd_usrp_probe --args="addr=192.168.10.2", I see the famous error message:

LookupError: KeyError: No devices found for ----->
Empty Device Address

The weird fact is that I have 9 other USRP N200 radios which get detected when I run the command uhd_usrp_probe --args="addr=192.168.10.2" on the same PC (so it shouldn't be a firewall issue). For the problematic USRP N200 I have done the following:

ping 192.168.10.1 which is fine

ping 192.168.10.2 which shows the error message that destination is unreachable

I have also used switch S2 to enter into safe mode, burn the right binaries (3.4.4 from maint branch), power-cycle the device but the problem persists.

Any ideas on what might be preventing the USRP N200 from being identified by the host PC?

Thanks in anticipation,

Mahboob