|
From: | Nemanja Savic |
Subject: | Re: [Discuss-gnuradio] Setting up clock synchronization blocks |
Date: | Thu, 21 Feb 2013 16:19:27 +0100 |
On Thu, Feb 21, 2013 at 02:10:24PM +0100, Nemanja Savic wrote:Your packet sync, but not your clock sync (how would the M&M even know
> Preamble is indeed long. On the figure I attached in my first post it can be
> seen the input and output od
> synchronization M&M block. I am expecting this block to do synchronization
> based on preamble.
about your preamble?).
Yeah, that's probably over the top. Filter and decimate, that saves
> Not quite sure that I understand, but I am sampling signal with ca. 500k, and
> symbol rate is 19.2k, so if you were thinking about oversampling after bit
> slicer, yes i have oversampling of ca. 25.
clock cycles and possibly improves your SNR.
I recommend parsing gr-digital/python/gmsk.py for an idea how this could
> In my receiver, after a bit filtered demodulated signal from quadrature FM
> demodulator, I have a block, designed by myself, that does bit slicing. It is
> basically simulation of a circuit that is used in
>
> some receivers with min and max diode detector circuits. Since I am quite sure
> this is not the usual way of doing this, how am I supposed to get digital
> pulses from demodulated signal.
be done (though, granted, that doesn't work perfect either, but also
doesn't sync via preamble).
MB
--
Karlsruhe Institute of Technology (KIT)
Communications Engineering Lab (CEL)
Dipl.-Ing. Martin Braun
Research Associate
Kaiserstraße 12
Building 05.01
76131 Karlsruhe
Phone: +49 721 608-43790
Fax: +49 721 608-46071
www.cel.kit.edu
KIT -- University of the State of Baden-Württemberg and
National Laboratory of the Helmholtz Association
_______________________________________________
Discuss-gnuradio mailing list
address@hidden
https://lists.gnu.org/mailman/listinfo/discuss-gnuradio
[Prev in Thread] | Current Thread | [Next in Thread] |