How can I set the sampling rate on both ends to be the same? FCDPP
sampling rate is 192 KHz.
If I include an audio sink, is the rate of the flowgraph controlled by
the sound card sampling rate?
Attached are my .grc files.
On Thu, Aug 8, 2013 at 11:34 PM, Alexey Bazhin <
address@hidden
Vanush Vaswani <
address@hidden <mailto:
address@hidden>> wrote:
> Hi there,
>
> I'm trying to stream the FCDPP over UDP to a another computer
> The setup is as follows
>
> FCDPP Source -> UDP Sink
>
> For the receiver,
>
> UDP Source -> LPF -> Quadrature demod -> FM Deemph -> LPF -> Audio
> sink
>
> Unfortunately, when I run the flowgraph on the receiver end, I only
> hear a bunch of clicks.
> The console is full of messages "WARN: Too much data; dropping
> packet.". WX GUI FFT Sink and Waterfall seem to work, though with the
> same messages.
>
> Any hints to rectify this issue?
--
Alexey Bazhin <