|
From: | Lin HUANG |
Subject: | Re: [Discuss-gnuradio] [USRP-users] best transmitter/receiver setup for large coverage |
Date: | Thu, 15 Aug 2013 20:21:16 +0800 |
Lin,
actually it is under the building please check here CORNET.
~Dilip
Date: Thu, 15 Aug 2013 19:49:38 +0800
Subject: Re: [USRP-users] best transmitter/receiver setup for large coverage
From: address@hidden
To: address@hidden
CC: address@hidden; address@hidden1 km is a long distance, so the lower frequency, the less pathloss. Use maximum tx gain and rx gain.And the distance may highly depend on the environment. Is there buildings, trees, or just a blank space?Lin2013/8/15 dilip thapa <address@hidden>
Hi,
I am using usrp2 and gnuradio 3.3.0.
I want to use benchmark_tx.py as transmitter and benchmark_rx.py as receiver.
so that multiple receiver at distance of around 1 KM should get good signal strength.
So could you please let me know the best options for tx and rx waveform, so I could get the maximum range of coverage.
best options means:
transmitter frequency, tx gain, tx amplitude and rx-gain, if there is any other then let me know.
I need this to do spectrum sensing with energy detection.
with Thanks,
Dilip
_______________________________________________
USRP-users mailing list
address@hidden
http://lists.ettus.com/mailman/listinfo/usrp-users_lists.ettus.com
[Prev in Thread] | Current Thread | [Next in Thread] |