[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Discuss-gnuradio] trouble with gr_multiply_const_ff
From: |
atools_cook |
Subject: |
Re: [Discuss-gnuradio] trouble with gr_multiply_const_ff |
Date: |
Sat, 30 Nov 2013 02:00:06 -0800 (PST) |
Hi Marcus,
Thanks for your attention.
I have upload a bigger size image below. the x axis is sampling point which
reflects time and the y axis is margin which reflects the power.
I plot the image from the rx block of the gen2_reader project. The signal is
transmitted by the tx block of gen2_reader.
The to_complex block is use to trasfer the float data to complex data for
transmitting by tx block.
The input data of gr_multiply_const_ff block are the same, they come from
the reader block.
It's weird that the output data of gr_multiply_const_ff are the same in
matlab image with different amplitude(bigger than 40 or not) but the signal
tx block transmiting are not.
I can't figure out how the amplitude in gr_multiply_const_ff block influence
the signal in tx block without change the output data.
By the way, we use a gen2_monitor with another usrp to get signal
transmitted from the gen2_reader tx blcok, it has the same signal image to
the rx block of gen2_reader. So, we can assume that there is no problem with
our equipments
Lee
<http://gnuradio.4.n7.nabble.com/file/n45025/amp5000.png>
--
View this message in context:
http://gnuradio.4.n7.nabble.com/trouble-with-gr-multiply-const-ff-tp45018p45025.html
Sent from the GnuRadio mailing list archive at Nabble.com.