[Discuss-gnuradio] Half-Duplex Relay

[David Halls]

Hi all,

 

Hopefully a very easy question! How do I implement a relay such that it will not begin transmitting until it has received a whole ‘burst’ of data. As there will be a direct path from source to destination, I don’t want the relay to start transmitting until the source has finished transmitting. Thus I want to implement a TDMA restriction where source transmits in time slot 1, then transmits nothing during time slot 2 (easy), then I want the relay to listen only in time slot 1 and then not begin transmitting until time slot 2.

 

I was wondering if I should use some kind of tagging?

 

Many thanks!

 

David

 

---------------------------------------------------------------

David Halls Ph.D.

Research Engineer

Toshiba Research Europe Limited

32 Queen Square, Bristol, BS1 4ND, UK

Tel: +44 (0) 117 906 0790

 

---

NOTE: The information in this email and any attachments may be confidential and/or legally privileged. This message may be read, copied and used only by the intended recipient. If you are not the intended recipient, please destroy this message, delete any copies
 held on your system and notify the sender immediately.

Toshiba Research Europe Limited, registered in England and Wales (2519556). Registered Office 208 Cambridge Science Park, Milton Road, Cambridge CB4 0GZ, England. Web: www.toshiba.eu/research/trl

---

This email has been scanned for email related threats and delivered safely by Mimecast.
For more information please visit http://www.mimecast.com

---