discuss-gnuradio
[Top][All Lists]
Advanced

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Discuss-gnuradio] uhd_fft not resonding


From: Richard Bell
Subject: Re: [Discuss-gnuradio] uhd_fft not resonding
Date: Thu, 18 Dec 2014 12:24:10 -0800

The key setting that mleech pointed out was setting the fft-rate lower, uhd-fft --fft-rate 5.

I suppose the N210 can't handle the default setting, since my laptop (corei7, 16 gig ram) doesn't seem to be the bottleneck going by cpu usage and mem usage.

On Thu, Dec 18, 2014 at 11:57 AM, Richard Bell <address@hidden> wrote:
When the window greys out, my CPU is only at 45% usage.

When I run uhd_usrp_probe I get all the device info you would expect to get. The command works as it should.

Rich

On Thu, Dec 18, 2014 at 11:48 AM, Ron Economos <address@hidden> wrote:
When a window greys out, it typically means you're using too much CPU.

Ron


On 12/18/2014 11:45 AM, Richard Bell wrote:
I created ~/.gnuradio/config.conf with the following lines in it

[wxgui]
style=nongl

This has not fixed the window not responding issue. Any other ideas?

Rich

On Thu, Dec 18, 2014 at 11:33 AM, Richard Bell <address@hidden> wrote:
I don't know if this matters, but I used the pybombs install method. I am looking for the .conf file, but the only thing in my .gnuradio directory is

~/.gnuradio/prefs/vmcrcbuf_default_factory

On Thu, Dec 18, 2014 at 11:29 AM, <address@hidden> wrote:

See "to enable OpenGL sinks" here:

http://sdrblog.wordpress.com/gnuradio-installation/

 

You'll use "style=nongl", instead of "style=auto" or "style=gl"

 

 

 

 

On 2014-12-18 14:25, Richard Bell wrote:

Yes I'm using Unity. I forgot to mention my hardware, which is an N210 with WBX daughterboard.

I'm not sure how to make the style change like you mentioned.

On Thu, Dec 18, 2014 at 10:54 AM, Martin Braun <address@hidden> wrote:
On 12/18/2014 07:39 PM, Richard Bell wrote:
> I'm using Ubuntu 14.04, UHD_003.008.00-18-g864f84b5 and GNU Radio 3.7.6
>
> Whenever I start uhd_fft from a command line, the window opens and
> starts to plot. After about a second, the window goes into not
> responding mode, where it greys out and you can't click anything. Does
> anyone know what could be causing this behaviour? Is it a local setting
> of mine?

Are you using Ubuntu's unity?

It might be a GL issue. Try if setting style = nongl will help.

M



_______________________________________________
Discuss-gnuradio mailing list
address@hidden
https://lists.gnu.org/mailman/listinfo/discuss-gnuradio

_______________________________________________
Discuss-gnuradio mailing list
address@hidden
https://lists.gnu.org/mailman/listinfo/discuss-gnuradio


_______________________________________________
Discuss-gnuradio mailing list
address@hidden
https://lists.gnu.org/mailman/listinfo/discuss-gnuradio


_______________________________________________
Discuss-gnuradio mailing list
address@hidden
https://lists.gnu.org/mailman/listinfo/discuss-gnuradio


reply via email to

[Prev in Thread] Current Thread [Next in Thread]