Re: [Discuss-gnuradio] flow graph issues migrating out of tree modules from 3.6 to 3.7

[address@hidden]

On Tue, Jul 28, 2015 at 10:14 PM, address@hidden <address@hidden>
wrote:

>  I just completed migrating an out of tree project from 3.6 to 3.7,
> consisting of several c++ files and associated .h files.    The GNU radio
> wiki page for describing how to do this was very helpful.  I finally got
> all the code to build aganst a GNU Radio 3.7x library.
>
> Problem is now the flow graphs will not run.  It can't find a uhd_swig
> module, which apparently was present in 3.6.
>
>
> Here are the messages I get
>  File "../common/path_ncbfsk.py", line 32, in <module>
>     import gtlib
>   File "/usr/local/lib64/python2.7/site-packages/gtlib/__init__.py", line
> 145, in <module>
>     _prepare_gtlib_swig()
>   File "/usr/local/lib64/python2.7/site-packages/gtlib/__init__.py", line
> 48, in _prepare_gtlib_swig
>     import gtlib_swig
>   File "/usr/local/lib64/python2.7/site-packages/gtlib_swig/__init__.py",
> line 129, in <module>
>     _prepare_uhd_swig()
>   File "/usr/local/lib64/python2.7/site-packages/gtlib_swig/__init__.py",
> line 32, in _prepare_uhd_swig
>     import uhd_swig
> ImportError: No module named uhd_swig
>
> Thanks in advance for any suggestions,
> Scott
>

My guess is that you need to rebuild UHD, and then rebuild GNU Radio's
gr-uhd against that. Here are the steps I would take:

0) get the latest UHD release, build, and install it
1) in your gnuradio root build directory, remove CMakeCache.txt
2) rm gr-uhd/* (in the build directory!) -- this shouldn't be necessary,
but it'll make sure that everything is rebuilt here.
3) rerun cmake and make sure it's picking up uhd as a component
4) rerun make and make install
5) test again to see if that fixes the problem

Tom
*****************************************************************


Thanks Tom.  I checked under 
/usr/lib64/python2.7/site-packages/gnuradio/

and it looks as if uhd is installed.

I found a  directory named "uhd" that appears to be configured as a python 
module (contains __init__.py file) as well as the following:
__init__.py   __init__.pyo        uhd_siggen_base.pyc  uhd_swig.py   
uhd_swig.pyo
__init__.pyc  uhd_siggen_base.py  uhd_siggen_base.pyo  uhd_swig.pyc  
_uhd_swig.so

Could it be that the gtlib_swig module should be importing it as "uhd" versus 
"uhd_swig", and that is why it is not
found?

Scott