Hi ,
I was working on the Wifi Transceiver Flowgraph. I created a loopback in the flowgraph itself to be sure that atleast the transceiver works in theory. It did work like magic.
Next I replaced the loopback with a uhd source and sink and connected the RF frontends using a SMA cable. It fails to give me any packet (the wireshark connector). I tried playing with the value of rx_gain and tx_gain. I also tried playing with the value of the the correlation threshold.
I then chose to debug using the data flow. The data in the flowgraph flows until the Decode MAC block where it gets dropped with checksum wrong message.