|
From: | Richard Bell |
Subject: | Re: [Discuss-gnuradio] Pybombs Prefix and Modtool |
Date: | Tue, 8 Mar 2016 10:44:18 -0800 |
If you're using PyBOMBS to install both GNU Radio and the OOT into the
same prefix, this is already happening. Also, once you've sourced
setup_env.sh, GRC_BLOCKS_PATH is also set. Are you mixing prefixes? I'm
not sure I fully understand your setup.
Cheers,
Martin
On 03/07/2016 10:32 PM, Richard Bell wrote:
> Thanks Ron, I will test it later tomorrow.
>
> Rich
>
> On Mon, Mar 7, 2016 at 2:53 PM, Ron Economos <address@hidden
>> address@hidden <mailto:address@hidden>> <mailto:address@hidden>> wrote:
>
> When you build your OOT module, you have to use the same prefix as
> your GNU Radio install. This is done in the cmake stage with
> -DCMAKE_INSTALL_PREFIX. For example.
>
> cmake -DCMAKE_INSTALL_PREFIX=/opt/gnuradio-3.7.10git ../
>
> Ron
>
>
> On 03/07/2016 02:21 PM, Richard Bell wrote:
>> Hi,
>>
>> I think I've narrowed down what I and some colleagues of mine have
>> been experiencing enough to explain it and hopefully get a solution.
>>
>> When I installed gr using the new pybombs, I specified a custom
>> prefix location (on several computers). It seems that later on,
>> when I create an OOT module using modtool, GRC does not interact
>> properly with these OOT modules, for some reason unknown to me
>> that I'm assuming is related to this prefix. The only workaround I
>> know to get OOT modules to show up in GRC now is to add each OOT
>> module directory path to the GRC_BLOCKS_PATH env variable. This
>> causes XML parser errors to be reported everytime I open GRC, and
>> slows it down.
>>
>> So my question is this:
>>
>> With the old pybombs, I always used the default prefix and
>> thereafter modtool always worked. After sudo make install and sudo
>> ldconfig, my OOT blocks showed up in GRC. Since now I chose a
>> custom prefix, is there an additional step I am supposed to take
>> when making OOT blocks?
>>
>> Summary: Installed GR using new Pybombs in custom prefix.
>> Installing OOT module custom blocks does not work without editing
>> GRC_BLOCKS_PATH variable for each OOT path.
>>
>> Thanks,
>> Rich
>>
>>
>> _______________________________________________
>> Discuss-gnuradio mailing list
>> https://lists.gnu.org/mailman/listinfo/discuss-gnuradio
>
>
> _______________________________________________
> Discuss-gnuradio mailing list
> address@hidden <mailto:address@hidden>
> https://lists.gnu.org/mailman/listinfo/discuss-gnuradio
>
>
>
>
> _______________________________________________
> Discuss-gnuradio mailing list
> address@hidden
> https://lists.gnu.org/mailman/listinfo/discuss-gnuradio
>
_______________________________________________
Discuss-gnuradio mailing list
address@hidden
https://lists.gnu.org/mailman/listinfo/discuss-gnuradio
[Prev in Thread] | Current Thread | [Next in Thread] |