|
From: | SangHyuk Kim |
Subject: | Re: [Discuss-gnuradio] Rx overflow problem related with sample rate |
Date: | Tue, 29 Mar 2016 12:50:56 +0900 |
On 03/27/2016 09:01 PM, SangHyuk Kim wrote:
Just specify it in the device arguments.Hi,
My Ethernet controller info.
Ethernet controller: Broadcom Corporation NetXtreme BCM57762 Gigabit Ethernet PCIeSubsystem: Apple Inc. Device 00f6Physical Slot: 9Flags: bus master, fast devsel, latency 0, IRQ 19Memory at acb00000 (64-bit, prefetchable) [size=64K]Memory at acb10000 (64-bit, prefetchable) [size=64K]Expansion ROM at a0a00000 [disabled] [size=64K]Capabilities: <access denied>Kernel driver in use: tg3
And I changed rmem_max and wmem_max but, it was not effect.
How can I change recv_buffer_size ??
Thanks
recv_buffer_size=<some_value>
In your device arguments
2016-03-28 0:37 GMT+09:00 Marcus D. Leech <address@hidden>:
On 03/27/2016 05:53 AM, tom x wrote:
That's not how Gnu Radio works. The blocks run on your PC.Hi,Have you tried other rates? What's the highest sample rate before overflow occurs?
>I think my PC can handle this sample rate
>How can I handle this problem ?
Maybe a power squelch block? You can filter out signals that don't meet a db threshold before they reach your PC.
https://gnuradio.org/doc/doxygen/classgr_1_1analog_1_1pwr__squelch__cc.html
However the power squelch I believe interrupts the sample stream, so that if you're writing to disk, the average write rate to the disk
is lowered in this case, depending on the dynamics of the amplitude of your signals, since you'll only be writing "good stuff".
If you're getting 'D', this may be your ethernet controller--what type do you have? The 82579LM is notorious for dropping data.
Also, make certain that your network buffering is configured correctly. See the notes here:
http://files.ettus.com/manual/page_transport.html#transport_udp_linux
On Sun, Mar 27, 2016 at 10:56 AM, SangHyuk Kim <address@hidden> wrote:
Hi,
I'm using USRP N210 with CBX daughter board on native Ubuntu 14.04
When I open fft_uhd with sample rate about 25 MSps, it spits out of "D"(overfow)
As I know, USRP N210 support sample rate up to 25 MSps and it's possible on Tx mode.
I think my PC can handle this sample rate, but I don't know why this is happened.
How can I handle this problem ?
Thanks.
_______________________________________________
Discuss-gnuradio mailing list
address@hidden
https://lists.gnu.org/mailman/listinfo/discuss-gnuradio
_______________________________________________ Discuss-gnuradio mailing list address@hidden https://lists.gnu.org/mailman/listinfo/discuss-gnuradio
_______________________________________________
Discuss-gnuradio mailing list
address@hidden
https://lists.gnu.org/mailman/listinfo/discuss-gnuradio
[Prev in Thread] | Current Thread | [Next in Thread] |